Browsing by Title

Sort by: Order: Results:

  • 28 Convocation 
    Unknown author (2014-11-14)
  • 31 Covocation of IUT held on 15 November 2017 
    Unknown author (2017-11-16)
  • 32 Convocation Newsletter 
    Patwari, Prof. Dr. Md. Anayet Ullah (IUT, REASP, 2018-11-08)
  • 3D CFD based optimization technique for muffler design of a motorcycle 
    Shadman, Sakib; Abir, Oneeruddho Hussain (Department of Mechanical and Production Engineering, Islamic University of Technology, Gazipur, Bangladesh, 2015-11-15)
    In order to minimize the sound transmission due to exhaust gases, the most common and important part of the engine system is muffler. A back pressure on engine is always produced due to the use of the exhaust muffler. This ...
  • 3D CFD based optimized muffler design, construction and prototype validation of motorcycle 
    Anwar, Ahmad Syed (Department of Mechanical and Production Engineering (MPE),Islamic University of Technology(IUT), Board Bazar, Gazipur, Bangladesh, 2016-11-15)
    In order to minimize the sound transmission due to exhaust gases, the most common and important part of the engine system is muffler. A backpressure on engine is always produce due to the use of the exhaust muffler. This ...
  • 3D Indoor Depth Mapping Using SIFT Feature Based ICP Registration 
    Sakib, Nazmus; Farayez, Araf (Department of Computer Science and Engineering, Islamic University of Technology, Gazipur, Bangladesh, 2015-11-15)
    3D mapping is one of the challenging research areas of Computer Vision and Robotics. Mappings are often done with mobile robots. One of the best approach is the use of SLAM (Simultaneous Localization and Mapping) where a ...
  • 3d Numerical Analysis of The Effect of Various Geometric Parameters of Eathes Under Steady Operating Conditions 
    Hero, Md. Kabbir Hossain; Moin, Md. Emran Hossain (Department of Mechanical and Production Engineering, Islamic University of Technology, Board Bazar, Gazipur, Bangladesh, 2018-11-15)
    Space heating and cooling is a comfort requirement which results in a significant amount of energy consumption. EATHE (Earth Air Thermal Heat Exchanger) is one of the passive ways of space heating and cooling that can ...
  • 3d Numerical Investigation of Flow and Heat Transfer Characteristics in Smooth Wavy Fin and Elliptical Tube Heat Exchangers Using ARW Vortex Generator 
    Sabbir, Shah Mohammad; Chowdhury, Sadat Hasan (Department of Mechanical and Production Engineering (MPE),Islamic University of Technology(IUT), Board Bazar, Gazipur, Bangladesh, 2017-11-15)
    3D computational analysis was performed to investigate heat transfer and pressure drop characteristics of flow in SWFET (Smooth Wavy Fin-and-Elliptical Tube) heat exchanger with VGs (vortex generators). The numerical model ...
  • 3D Object Detection with Stereo Vision and Transformer 
    Samin, Abid Ahsan; Hassan, Abdullah; Khan, Md. Rakib Hossain (Department of Computer Science and Engineering(CSE), Islamic University of Technology(IUT), Board Bazar, Gazipur, Bangladesh, 2022-05-30)
    Identifying 3D objects with computer vision in a precise manner has been a challenging task in the field of autonomous driving. Partly because it requires proper depth estimation. Until now, Li-DAR technology has been ...
  • 4G Data Analysis and Downlink Throughput Predictive Modelling Around The Geographic Region of Gazipur and Dhaka 
    Chowdhury, Shafi Muhtasim; Islam, Safwan; Islam, Rafrafin (Department of Electrical and Elecrtonics Engineering(EEE), Islamic University of Technology(IUT), Board Bazar, Gazipur-1704, Bangladesh, 2024-06-22)
    This project presents a comprehensive study on optimizing 4G data analysis and downlink throughput modelling, integrating technical rigor with societal considerations. As 4G networks continue to serve as a backbone for ...
  • Abundance and Characteristics of Microplastics in Urban Canals: A Case Study In Dhaka City 
    Rahman, Fahad; Nabi, Mohammed Fahamidun (Department of Civil and Environmental Engineering(CEE), Islamic University of Technology(IUT), Board Bazar, Gazipur-1704, Bangladesh, 2024-11-30)
    Microplastic pollution is an emerging global environmental challenge with significant implications for aquatic ecosystems and human health. This study focuses on the urban canals of Dhaka city, Bangladesh, where the ...
  • Abundance, Characteristics and Ecological Risks of Microplastics in River Sediments around Dhaka City 
    Islam, Md. Saiful (Department of Civil and Environmental Engineering (CEE), Islamic University of Technology (IUT), Board Bazar, Gazipur, Bangladesh, 2022-11-30)
    Microplastics (MPs), the small particles of plastics with a size less than 5 mm have been identified as an emerging pollutant in recent decades. Microplastics pose a higher risk in the aquatic environment and also a ...
  • Accelerometer based gesture recognition system 
    Mahmud, Jisan; Abrar, Murad Mahbub; Toha, Zakaria Rabbi (Department of Electrical and Electronic Engineering, Islamic University of Technology (IUT), Board Bazar, Gazipur-1704, Bangladesh, 2012-11-15)
  • Accessible Design and Fabrication of Wheelchair Ramp for Public Bus Transportation and Design Study Based on SolidWorks Simulation 
    Ahmed, Syed Tasnim; Islam, Sakib Ul (Department of Mechanical and Production Engineering (MPE),Islamic University of Technology(IUT), Board Bazar, Gazipur, Bangladesh, 2017-11-15)
    There are an estimated 5.6% people in Bangladesh who have a disability of one kind or another and about 28% of disabled people have physical disabilities. Movement accessibility is an important enabler of strategies to ...
  • Activities Completed in Capital Management, Investment Corporation of Bangladesh 
    Aunkon, Navid Islam (Department of Business and Technology Management(BTM), Islamic University of Technology(IUT), Board Bazar, Gazipur-1704, Bangladesh, 2022-05-30)
    This report is about Investment Corporation of Bangladesh (ICB), which is one of the country's main financial organizations in the investment banking and mutual funds industries. The main purpose of my report was to ...
  • The Activities of Supply Chain management of Standard Group 
    Tahmid, Gazi Ahnaf (Department of Business and Technology Management(BTM), Islamic University of Technology(IUT), Board Bazar, Gazipur-1704, Bangladesh, 2023-05-30)
  • Activity Recognition of a Badminton Game Through Accelerometer and Gyroscope 
    Anik, Md. Ariful Islam; Hassan, Mehedi (IUT, CSE, 2016-11-20)
    The scope for doing physical exercises in daily life is declining day by day. But, the importance of human physical exercise for a healthy life, remains the same. It is necessary to generate a solution to simulate the ...
  • Ad Operations, Marketing, NEXT Ventures 
    Morshed, Maisha Maliha (Department of Business and Technology Management(BTM), Islamic University of Technology(IUT), Board Bazar, Gazipur-1704, Bangladesh, 2023-05-30)
  • Adaptive Control of CRE with Proportional Fair Resource Scheduling in LTE HetNets 
    Al Islam, Md. Nafee; Arman, Shahed; Bhuiyan, Rokibul Hasan (IUT, EEE, 2016-11-20)
    Cell range extension (CRE) has been used as a method to increase the area under the small cell and balance the loads between small and large cell by adding a cell selection offset (CSO) to small cells in heterogeneous ...
  • Adaptive Robust Local Complete Pattern For Facial Expression Recognition 
    Rubel, Al Shahriar; Chowdhury, Ahsan (Department of Computer Science and Engineering, Islamic University of Technology, Board Bazar, Gazipur, Bangladesh, 2018-11-15)
    An effective and robust face descriptor is an essential component for a good facial expression recognition system. Many popular appearance-based meth- ods such as local binary pattern (LBP), local directional pattern (LDP) ...

Search IUT Repository

Browse

My Account